By 
So you've picked up a chandelier to your liking, do not forget to take into account with all the necessary requirements (characteristics of the premises, technical features chandeliers). Now you only have to hang a chandelier on the ceiling. To hang chandelier you will need: pliers screwdriver voltage tester adhesive tape knife ladder assembly chandelier place in several stages. First of all you must turn off the total food on the counter in the apartment hallway any machine on the counter. Be sure to check the absence of tension with a screwdriver indicator. Further mounted attachment point chandeliers on the ceiling. Ceiling hook on which to hold the chandelier is wrapped insulating tape, checked for strength.
Next Fixture Chandelier is applied to the ceiling and marked the mounting holes. Drill holes in the ceiling, they insert dowels and bolted fasteners. On next phase of work to plan lighting in the room. Think of a switch you will need: one-or dvuhklavishny. As a rule, the hall is set dvuhklavishny switch to illumination in the room could be changed depending on the situation. Make a light in the room brighter or, alternatively, to muffle the lighting, you can use different amounts of time the lamp.
For example, when circuit breaker can burn one or two bulbs, and all three by pressing all the keys. Typically, a 5-carob chandelier combine 2 and 3, the burning lamp or lamps 1 and 4 (vzavismosti on design and on the willingness of the landlord). Then need to combine the wires into groups depending of type of bulb combinations. From each patron leaves on 2 wires. So, if you have a 3-Crow chandelier at the top of the tube comes out six wires, with a 5-Rozhkova chandelier – 10 wires. Consider three ways to connect the wires in the groups: 1) for 3-Rozhkova chandelier: a combination of lamps 1 and 2 (Scheme 1) 2) 5-Rozhkova chandeliers: both tubes 2 and 3 (Scheme 2) 3) 5-Rozhkova chandeliers: both tubes 1 and 4 (Scheme 3) To understand what wire departs from each cartridge in the chandelier, in two ways: either mechanically (by pulling each wire in the tube), or the method of "continuity" (battery with a bulb).